124971941BIW1000_1200W.qxd 11/20/00 2:33 PM Pagina 24 (Nero quadricromia/Process Black pellicola)
UnpackingPositioning
Install the machine on a flat hard floor.
All transit bolts and packing must be removed
Make sure that air circulation around the machine is not
before using the appliance.impeded by carpets, rugs etc. Check that the machine
does not touch the wall or other kitchen units.
You are advised to keep all the packaging for re-use inNever place cardboard, wood or similar materials under
case the machine is to be transported again.
the machine to compensate for any unevenness in the
Using a spanner unscrew and remove the rear right bolt.floor.
Lay the machine gently on its back, making sure that theYour new washing machine has been designed to be
hoses are not squashed.
permanently plumbed in to your home?s water supply
and drainage system. However, if this is not possible, it
may be connected to suitable existing taps with the drain
hose discharging into a sink.
The appliance has two inlet hoses, hot and cold, with
female 3/4? BSP thread connectors. If this connection is
not compatible with the plumbing of the existing
installation, a variety of connectors are available from
good hardware stores and plumbers merchants to suit
most domestic plumbing. Any alteration to your existing
Remove the polystyrene block from the bottom of the
plumbing must be carried out by a competent person, or
machine.qualified plumber.
Carefully slide out the right polythene bag (1).
Repeat the operation for the left polythene bag (2).
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to
vibration. To help prevent vibration we recommend you
place a waterproof wood panel, at least 15 mm thick
under the appliance, secured to at least 2 floor beams
with screws. If possible install the appliance in one of
the corners of the room, where the floor is more stable.
Water inlet
Remove the polystyrene base.The inlets on the back of the appliance are colour coded,
Set the machine upright and remove the two remainingblue for cold and red for hot.
bolts from the back.
Connect the hoses to taps with 3? thread.
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
Plug all the holes with the plugs which you can find in
the envelope containing the instruction booklet.
24 |
ACEC
